ilikebion.blogg.se - Loxone miniserver

Loxone miniserver Patch#

Probably a safety margin or rounding error.

a one cluster directory with two entries: LOXONE_SD as the volume label and a LOXONE1.FS file.

a FAT32 with 955 sectors, starting at sector #32 (directly after the hidden sectors).

a copy of the FS Information sector #1 in sector #7 (ignore by the Miniserver).

a copy of the boot sector #0 in sector #6.

3911551 sectors (a bit more than 1.9GB).

The FAT32 system on a 2GB memory card is pretty standard: You can not just copy this file onto a different disk, because the FS Information Sector needs to point to it and it can't be fragmented in any way. It is addressed directly, the FAT32 filesystem is ignored. It contains a single file 'LOXONE_SD', which occupies the whole medium. The Micro-SD card is a standard 2GB memory card with a FAT32 filesystem on it.

This filesystem is only accessed by the Miniserver firmware. The SD card also contains the file system, which is used for the configuration, the web server and all additional files, like statistics. The Miniserver loads the firmware from the SD card via a little boot loader, which exists in the flash memory on the board. Dont' forget to always make a full backup of your SD card first! Intro

Loxone miniserver Patch#

You could even patch the firmware image to load whatever firmware you like.īecause everything is stored on the SD card itself, you always switch to a fresh SD card, if your experiment fails.The Miniserver has only very rudimentary repair code in place. You can also use this to validate if the file system is correct.If the SD card is damaged, this document might help you to potentially recover files.This means there is typically no need to dig into the SD card to recover a file. All files are directly accessible via FTP directly – which is non obvious, because the FTP server could filter the available list of files.